Attach a diamond blade to your circular saw for use on the concrete surface.
Cut concrete floor with circular saw.
You may want to cut some blocks for your yard cut a wall or slab or whatever you want but if you are trying to cut it you have to do it in the right way because it s actually a hard job to do and instead of hiring a contractor to do the job and it may cost you a lot of money you can do it all by yourself if you.
In this video we are cutting concrete with a circular saw aka skil saw.
In this article we ll be taking a closer look at how this device functions and how to accurately cut concrete with it.
Concrete is a mix of sand gravel cement and water and it is everywhere.
The cut will come out smoother with less dust.
Forget about circular saws concrete blades and jackhammers.
There are several types of hand held saws wet or dry that are good for most concrete cutting.
So if possible cut the concrete when it s hard but only half cured.
The blade that i am using is a bosch db741c 7 inch premium segmented diamond blade.
Mark your cutting line onto the concrete using a 2 by 4 as a straightedge to guide the chalk.
Next set the saw s blade depth to 2 inches and attach a 7 inch diamond blade using vice grips so that the teeth point in the opposite direction of movement.
To cut through the steel and concrete rent a walk behind concrete wet saw fitted with a diamond blade.
Wet concrete is very difficult to cut and fully cured concrete can fracture as it s being cut.
Specially designed to cut through masonry materials for prolonged periods the masonry wall saw typically resembles a standard circular saw.
Set the blade to the required cutting depth.
Orange chalk works well as.
However whereas the base plate of a standard circular saw prevents workers from cutting flush against a wall the masonry wall saw s base is designed to allow builders to create cuts at the intersection of walls and floors.
The battle can be won by selecting the correct tool and in this case that would be the circular saw.
Cutting hollow concrete block next chip away the waste after scoring remove the concrete to one side of the line using increasingly hard whacks of a hand sledge.
Then face the chalk line at a 45 degree angle and use your dominant hand to.
Place the saw onto the surface of the concrete with.
A circular saw with a masonry blade can also be used to either score or completely cut through the block.
