When we cut with a circular saw we often install the blade backwards to minimize ripping and tearing of the vinyl.
Cut hole vinyl siding.
Not just any circular saw blade will do.
Place that strip of vinyl siding so that the piece and the line you want to cut are slightly off the.
Make the line as dark as possible so it s visible when you re cutting it.
Follow these steps on how to cut vinyl siding with a circular saw.
Place a strip of siding on the work table and align the place you plan to cut it with the edge of the table.
Fit a circular saw with a fine toothed plywood cutting blade.
This method is best for cutting a lot of short or long vertical cuts since the circular saw will create clean incisions relatively quickly.
When making longitudinal cuts score with a knife and break along the score line.
Clean the siding around the hole with vinyl siding cleaner or dish detergent and water then dry the siding.
A hole saw tin snips etc will slice right through it.
It should snap apart.
This is a trick on how to cut vinyl siding the quickest and easiest way without breaking or chipping it.
Cut a scrap piece of siding to a length that is several inches longer than the hole.
If you re cutting dark vinyl siding use chalk or light colored tape to mark the line you want to cut.
Cutting the vinyl siding is easy.
Holes an inch or two across or long narrow holes that still appear patchable require removing the damaged piece of vinyl to fix it.
You can also use tin snips to make crosscuts.
That said the hole is the least of your effort.
Mark the line you want to cut on the siding with a pencil.
The best way to cut vinyl siding circular saw.
Using a circular saw is the first method that you can use to cut vinyl siding.
A clean way to cut vinyl siding is to score it with a utility knife and then bend the vinyl at the score.
I would cut from the outside on top of the vinyl siding not sure where you are if it s too cold outside but the vinyl siding may crack beyond the hole s diameter you are trying to cut it from the inside.
First lay a strip of vinyl siding onto a flat and clean working table.
You ll need a fine tooth plywood saw blade to do this correctly.
With a pencil and measuring tape mark.
The blade you want to use is a general purpose blade that can cut wood metal this will also work on vinyl but be careful regardless of which blade or tool you use if there is too much heat built up on the blade during use the vinyl may melt the vinyl.
Use tin snips or a rotary tool to make curved cuts.
Make crosscuts on vinyl siding using a circular saw but you should install a vinyl cutting blade to minimize chip out.
Cover the hole from the back side with foil tape then put the siding back where it belongs.
