Cyclone How To Had Tension To Awning

2 the support arm consists of an outer and inner section.

Cyclone how to had tension to awning.

As i stated before it was the first one i installed that i didn t do correctly and it sprung. Basically you grasp the end piece with vice grips and have your helper be ready to re insert the cotter pin. The fabric and the arms have to be centered for it to work properly. The tension arms are what you adjust to make the awning taut after it has been lowered.

The struts that push out the awning usually won t get more tension they will loose it since they are filled with gas. Remove the 2 phillips head screws from the bottom end of the outer section. Reattach the rear awning leg and lower both leg sections completely. They are showing me how to install.

Insert the cotter pin to hold the spring tension. Roll the awning back up to observe how tight it is. Replace the awning arm on the end piece and replace the bolt. Leave on side of the awning slightly lower when raising your awning to the desired height.

Adjust awning tension adjust spring tension rv awning how to adjust the tension on an rv awning awning tighting adjustments how to adjust spring tension on rv awning rv awning tension loose adjust rv awning spring rv awning spring tension. See our channel page for link the home on the road series consists of three 2 dvd. If you are satisfied move on. This will reduce the weight on the awning and help ensure adequate tension is retained.

The manuals you forwarded to me are not explaining how to put tension back on the awning. I m actually very handy and i have had another person helping me install three of them. By doing this any water that collects will drain off. Wind the spring by the number of turns indicated for your model in the direction indicated on the end cap.

Now you are ready for the front. Using a de flapper can help prevent damage by providing tension. With the awning out try pushing it in by hand at each side and this will tell you if there is a bind or restriction on the system. You do not need to put the screws back in.

Take the awning arm laying against your coach and the one still in the leg and reconnect them by sliding the one in the arm up and realigning the knob bring it all the way back up until it clicks into the knuckle push on the leg to tighten the awning fabric and tighten that knob back up.