Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
Deck ledger over siding.
This will give you a to of extra room to maneuver the ledger if needed.
The ledger was all rotten as it was sitting tight to the siding so i assume water was accumulating behind it and was stuck there.
Make sure you have enough room to install flashing above the ledger board and allow for at least a space above the decking preventing water from wicking upwards into wood siding.
Make the outline large enough to allow space for the.
This may seem excessively tall but is needed in order for the water resistive barrier wrb and siding to overlap the top.
Deck ledger board.
Remove siding determine the outside dimensions of the framing for the deck and add to 1 to that length.
Start by making an outline on the siding where you want to position the ledger board.
Start by using plunge cuts across the top and bottom of the horizontal length of the ledger board followed by the shorter vertical cuts for the ends using a cold chisel.
Then slip flashing behind the siding covering the top edge of the ledger.
Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape measure pencil and chalk line.
The attach a deck is a simple deck ledger mounting system that stands the ledger off the wall eliminating the need for flashing that s the big benefit but there are other features i like.
Deck ledger board deck ledger spacers.
Attach a deck can be used to mount ledgers on new homes and retrofit decks over siding on existing homes the system is tested by an engineering service the installation is simple and fast lag screws can be used something the 2009 prescriptive ledger mounting table only permits for bolted ledgers.
After the ledger is installed a second strip of membrane tape is applied over the top of the ledger and about 1 2 in.
Determine the floor joists location so that you will know exactly where to cut and remove the siding.
Mark the ledger length.
The wall leg is at least 7 in.
How to attach ledger board on siding mark the top of the ledger.
Snap a chalk line cut out the siding and tack up the ledger board.
Learn how to cut and remove aluminum vinyl wood and cement board siding for installing a deck ledger board to a house wall.
Set a water level on mark done for the ledger board then make another at a point longer than.
