Tie a knot at one end of the 10 foot rope.
Diy gutter planter.
Garden answer youtube.
Thread the unknotted end of the rope through one of the holes in the bottom of the left gutter section and then out the.
Repeat threading up through the bottom hole and out through the side hole on the next two left gutter sections.
Measure 12 inches of.
Using a marker mark your hole marks at 3 inches over and 1 2 inch down see the image 1 bottom of gutter below next drill the holes on the front and back of the gutter.
Start by drilling the bottom holes using your drill and 3 8inch bit.
10 ft vinyl gutter but i only used about 6 feet of it 3 sets vinyl gutter end caps 1 4 inch natural fiber rope it comes in 50 feet rolls which is plenty home depot pdf instructions.
Then thread the brace piece through the same clamp and tighten it with a screwdriver.
This will lock each segment along the suspension wire.