Do I Sand The Wood Floor After The Slurry Seal

But often that s the wrong solution.

Do i sand the wood floor after the slurry seal.

Refinishing hardwood floors is the right solution. Floor finishes can emit harmful vapors so be sure the area is well ventilated as you work. Sanding sealers dewaxed shellac and wipe on finishes will all do the trick. All wood floors are protected by a clear coating that eventually becomes scratched scuffed and dull.

Allow to dry for one hour. Some types of stain perform better than others on blotch prone wood. Paint thinner for oil modified. Typically you would do this with a drum floor sander a large piece of equipment you can rent from home improvement stores.

Should you be sealing your wood before you stain or after. Any scratches will be enhanced by stain. Make sure you remove any sanding dust from the surface. Make sure you sand the wood well before applying stain.

Follow the grain of the wood. Start with 80 grit to remove big scratches and imperfections then move up to 120 and finally 220 grit. Begin by using a drum sander or belt sander with the grain along the length of the boards. Use patience so you only have to apply a.

I hope this video clear. If you seal it while it is sticky it may never get fully dry and hard. Once you have a layer of finish on the floor any time you sand and tack the floor you will need to use a damp tack rag just dampen a cloth microfiber cloths work particularly well with the solvent that matches your finish water for waterbornes. Try to apply as even a coating as possible.

I like to wait 24 48 hours to let the stain dry before sealing. Sanding will also help open up the pores of the wood so that they can absorb stain better. Select a stain that won t raise the grain of the wood or you ll have to sand the floor after applying the finish. Rough sand the floor sanding eliminates scratches and stains from a hardwood floor but may not be able to alleviate the deepest gouges or discolored patches of wood.

Always wear a dust mask safety goggles and ear protection when using a drum sander. The key is to apply a thin base coat to partially seal the wood before wood staining. Once the protective layers of sealer have been removed you continue to sand the hardwood to remove any scratches nicks or other imperfections. When a wood floor loses its luster the usual solution is to sand it down to raw wood and completely refinish it.

You do not want to seal wood that is wet or tacky in any way. If it it very cold hot or humid wait up to 72 hours.